Additional Specs, Equipment and Information:

Boat Name
Contour 30 Mk II

Specs
Builder: Paul Countouris
Designer: Cole Beadon
Keel: Centerboard

Dimensions
LOA: 30 ft 0 in
Beam: 23 ft 10 in
LWL: 28 ft 6 in
Bridge Clearance: 46 ft 6 in

Engines
Engine 1:
Engine Brand: Outboard
Engine Model: Honda BF9.9A
Engine/Fuel Type: Gas/Petrol

Specifications
Designer: Cole Beadon
Builder: Contour Yachts, Canada
LOA:30.00 ft
LWL: 28.83 ft
BOA: 23.83
Docking beam: 11 ft
Trailering beam: 8 ft 6″
Draft: 1′ 4″– 5′ 9″
Sail area: ~570 sq ft

Accommodations
The Contour 30 sleeps four comfortably, two in the large, private V-berth (6’10”x4’8”) and two in the main cabin. The main cabin features a teak and holly cabin sole and is trimmed with teak. There is 6’ 2” standing head room in the main cabin. A cabin table is included.
An enclosed head compartment is forward to port. The head itself is a Jabsco marine toilet with a 15 gal holding tank and deck pumpout. There is a sump with a manual pump in the head.

Galley
The galley is aft by the main cabin entrance. The sink with manual pump is to starboard. Amidship is a space for a portable stove. There is a 5 cu ft ice box to port.
Removable saloon table

Electronics
VHF radio, Uniden Oceanis
Wind display, Raymarine ST40
Depth display, Nexus Silva
Speed display, Nexus Silva
GPS chartplotter, Garmin Echomap 74dv with swing out arm (can be used in cabin or cockpit)

Electrical
12V electrical system with battery switch and circuit breaker panel
battery replaced in 2017
? watt solar panel with HQRP charge controller

Sails
Mainsail, spectra, two reef points, good condition
Jib with Schaefer System 650 furling system, good condition
Genoa, spectra
Screacher, spectra

Deck
Rotating double spreader aluminum mast
Strong mainsail track – easy hoist/lower on any point of sail
Swing-wing folding system
Roller furling for genoa and screacher
Harken hardware
Harken 6-1 mainsheet with 4-1 tweaker
3 Ocean series Lewmar hatches
5 opening ports
4 Lewmar #40 self-tailing winches
Bow sprit with side stays – for screacher and spinnaker
Built in Bimini with new cover
7’ cockpit
Forward crash bulkhead
All tracks and blocks are Harken
Bimini
Compass

Motor
2006 Nissan 9.9 4 stroke outboard motor
electric startjust serviced including new water pump impeller and starter motor

Trailer
1994 Marine Cradle Shop road trailer
repainted 2018
new hitch coupler and brake master cylinder 2018
all ownership/registration paperwork up to date

Miscellaneous
Built in manual bilge pump
Line bags, winch handle holders, winch handles
Fenders, dock lines
Anchor 18 lb Danforth w/ rode and chain

Tankage
Fresh Water: 20 gal US
Holding: 15 gal US

Recent upgrades and maintenance
Interior fully repainted and all lighting replaced with LED lightsRigging professionally inspected in 2015 and boat has only been used for three months since.New bilge pumpBottom soda blasted and epoxy barrier coat applied summer 2017Mast repaintedBoom repaintedBowsprit repaintedDaggerboard and rudder regelcoated summer 2017Bilge painted with bilgecote in summer 2017All interior and exterior wood refinished in 2016

Amas regelcoated in 2016 (main hull did not need it)
All cabinets  rebuilt using Azek (impervious to water). Tthe original wooden cabinets are available if desired

Disclaimer
180 Marine offers the details of this vessel in good faith but cannot guarantee or warrant the accuracy of this information nor warrant the condition of the vessel. A buyer should instruct his agents, or his surveyors, to investigate such details as the buyer desires validated. This vessel is offered subject to prior sale, price change, or withdrawal without notice.